WILDENAODD pumps, kits & parts

WHITEPAPER · 2026-09-28

Whitepaper: diaphragm and elastomer selection for WILDEN AODD pumps

How diaphragm and check-valve materials in the model code affect chemical compatibility, flex life and spare-part planning.

Diaphragms are the primary wearable seal on an air-operated double-diaphragm pump. This whitepaper summarises how to read material choices in WILDEN complete model codes and how to plan replacements without copying manufacturer manual text.

Why the model code matters

The complete ordering code encodes diaphragm and valve materials. Two pumps with the same centre section and port size can still need different wet kits if the elastomer letters differ. Always key spares to the code on the nameplate. The catalogue pages list the diaphragm material that belongs with each item number; they do not invent a substitute.

Elastomers vs PTFE-class diaphragms

Elastomer diaphragms suit many water, slurry and mild chemical duties inside their temperature limits and offer good flex life when the fluid is compatible. PTFE-class and composite diaphragms are selected when chemical attack or purity requirements rule out common elastomers. Flex life, temperature and cleanability trade off against each other — pick from the coded options, then validate against your fluid list.

Duty conditions

Temperature, solids size and suction conditions matter as much as chemistry. A material that is fine at ambient temperature may harden or soften at the duty temperature listed on your P&ID. Maximum solids diameter and suction-lift figures on the product page are configuration-specific — use the values printed for that item, not a generic series brochure figure.

Check valves and seats

Balls, flaps and seats must be chemically compatible and sized for the solids the pump will see. Flap valves appear on larger-solids duties; ball valves remain common on cleaner fluids. A pump coded for one ball material should be repaired with that material unless an applications engineer has approved a change for a new fluid. Replacing only the diaphragm while leaving swollen or worn seats in place often returns the pump to the workshop within weeks.

Sanitary constraints

Saniflo FDA and Hygienic Series (HS) configurations constrain materials and options for regulated duties. Use the FDA and HS category pages when those builds are required. Do not assume an industrial elastomer set is acceptable on a hygienic line.

Change management

If the process fluid changes, treat diaphragm material as a management-of-change item. Compare the existing complete model code with the new fluid data, then enquire for a re-code or a wet kit that matches the new duty. Record the new item numbers in the storeroom so the next shift does not fit the old kit.

When you re-purpose a spare pump onto a new fluid, compare the existing complete model code with the chemical compatibility data you use in-house, then enquire for a re-build kit or a different configuration if the materials are wrong.

Spare-part practice

Stock wet kits by diaphragm material family, not only by pump size. Label shelf bins with both kit item number and the pump codes they serve. Attach nameplate photos to storeroom records for critical tags.

All whitepapers · Application Cases · Send an enquiry