Item: 04-12207 Model: P4/PPAPP/VTS/VT/PTV/0504 Series: Pro-Flo Wetted material: Polypropylene Diaphragm material: FKM Nominal fluid port size: 1.5-inch Construction: Clamped
WILDEN / PRO-FLO SERIES
This 1.5-inch Pro-Flo air-operated double-diaphragm pump uses polypropylene wetted housing and FKM diaphragms. Its clamped construction is identified by the complete ordering code below.
Complete model
P4/PPAPP/VTS/VT/PTV/0504
FLUID PORT SIZE
1.5-inch
MAXIMUM FLOW
≈ 348.3 L/min
MAXIMUM PRESSURE
125 psig
| Brand / item number | WILDEN / 04-12207 |
|---|---|
| Pump series | Pro-Flo |
| Nominal fluid port size | 1.5 in |
| Construction | Clamped |
| Wetted housing | Polypropylene |
| Diaphragm material | FKM |
| Diaphragm design | TRADITIONAL |
| Diaphragm stroke | Full-Stroke |
| Check ball material | FKM |
| Valve seat material | Polypropylene |
| Power source | Compressed Air |
| Inlet / discharge orientation | Center Swivel / Center Swivel |
| Maximum flow | 92 US gpm (approximately 348.3 L/min) |
|---|---|
| Maximum operating pressure | 125 psig (approximately 8.6 bar) |
| Maximum air supply pressure | 125 psig (approximately 8.6 bar) |
| Maximum solids diameter | 0.18 in (approximately 4.6 mm) |
| Listed dry suction lift | 16 ft (approximately 4.88 m) |
| Listed wet suction lift | 26 ft (approximately 7.92 m) |
| Listed operating temperature | 40–175 °F (approximately 4.4–79.4 °C) |
| Self-priming | Yes |
| Listed shipping weight | 37 lb (approximately 16.78 kg) |
Maximum flow and maximum pressure are separate ratings. Check the duty point, fluid compatibility, temperature and suction conditions for the complete pump configuration.
| Air-side material | Polypropylene |
|---|---|
| Outer pistons | Polypropylene |
| Wetted O-rings / gaskets | PTFE-encapsulated FKM |
| Hardware material | Stainless steel |
| Muffler | Plastic |
| Special option code | 0504 |
AIR REPAIR KIT
Air distribution service kit matched to this 1.5-inch Pro-Flo P4 configuration. Confirm the complete pump code when ordering.
WET-END REPAIR KIT
Wetted-end service kit matched to this 1.5-inch clamped pump with FKM diaphragms. Match the installed elastomers and full ordering code.
Repair kits are ordered separately. Include the complete pump code and kit number in your enquiry.
Quote 04-12207 and P4/PPAPP/VTS/VT/PTV/0504, together with quantity, fluid, operating temperature, required flow and discharge pressure. For replacement parts, include the component number and a clear pump nameplate photo.
Build an evidence-based WILDEN AODD pump air-cos
Investigate low WILDEN AODD pump flow with a str
Compare WILDEN Saniflo FDA and Hygienic Series p
Contact: Kevin
Phone: +86-17717557262
Tel: +86-17717557262
Email: willeepump@gmail.com
Add: No. 133, Dongzheng Village, Lingang New Area, China (Shanghai) Pilot Free Trade Zone
English
